5 -
Rear mudguard - Splash guard
1
Long rear mudguard
2
Rear mudguard
3
Rear splash guard
4
Special screw
5
Special screw
6
Screw
7
Chain guard
8
Special screw
Spare parts catalogue
1200 ABS
swingarm
1200 S ABS
swingarm
Important
Bold reference numbers in this section identify parts not shown in the figures alongside the text, but
which can be found in the exploded view diagram.
Removing the rear mudguard
Undo the screws (5) and (6), remove the rear mudguard (2) from the swingarm.
Refitting the rear mudguard
Place the rear mudguard (2) on the swingarm, fitting the screws (5) and (6).
Tighten screws (5) and (6) to a torque of 5 Nm ± 10% (Sect.
3 - 3,
Frame torque settings
).
Long rear mudguard kit
Remove the rear mudguard (2) as indicated in paragraph “
Removing the rear mudguard
” of this section.
Position the long rear mudguard kit (1) on the swingarm by starting the previously removed screws (5) and (6).
Tighten screws (5) and (6) to a torque of 5 Nm ± 10% (Sect.
3 - 3,
Frame torque settings
).
Removing the splash guard
Undo screws (4) and (8) to remove the splashguard with chain guard from the rear swing arm.
Remove the splashguard (3) from the chain guard (7).
Refitting the splash guard
If previously disassembled, reassemble the chain guard (7) with the rear splashguard (3) as shown in figure.
Place the splashguard with chain guard on the swing arm.
Apply the recommended threadlocker on the screws (4) and (8).
Start and tighten the retaining screws (4) and (8) to a torque of 10 Nm ± 10% (Sect.
3 - 3,
Frame torque settings
).
1
Spare parts catalogue
Important