Bold reference numbers in this section identify parts not shown in the figures alongside the text, but which can be found in the exploded view diagram.

Loosen and remove the screw (4) with the spacer (3) fixing the radiator to the headlamp support. Remove the radiator by sliding it from the pin (F) of the headlamp support.

Loosen the nipples (5) on the radiator and collect the gaskets (6).

If the nipples (5) have been removed from the radiator insert a washer (6) on each nipple (5) and apply specific threadlocker on threads on the radiator side.

Insert the nipples (5) on the oil cooler (1) and tighten them, counterholding the hex nuts (E), to the specified torque of 23 Nm± 10% (Sect. 3 - 3, Frame torque settings).

Tighten the ring nuts (E) to the torque of 18 Nm ± 5% (Sect. 3 - 3, Frame torque settings) counterholding the hex nuts on the nipples.

Tighten the screw (8) to the torque of 10 Nm ± 10% (Sect. 3 - 3, Frame torque settings).

Tighten the screw (4) to the torque of 6 Nm ± 10% (Sect. 3 - 3, Frame torque settings).

If previously removed, place the sensor (12) with washer (13) on cooler and tighten it to a torque of 19 Nm ± 10% (Sect. 3 - 3, Frame torque settings).