Bold reference numbers in this section identify parts not shown in the figures alongside the text, but which can be found in the exploded view diagram.

Fit the side stand leg to the bracket and check that there is no excessive clearance. Ensure that the ends of the side stand are not bent with respect to the shank.

To check the switch (2) refer to Sect. 6 - 8, Side stand button.

Insert the side stand (1), properly greased, in the bracket (4) and fix it with the pivot (9) and the nut (8).

Tighten the nut (8) to the torque of 20 Nm ± 10% (Sect. 3 - 3, Frame torque settings).

Place the switch (2) on the bracket, on its pin (9).

Fit the retaining screw (5) with recommended threadlocker and tighten it to a torque of 5 Nm ± 10% (Sect. 3 - 3, Frame torque settings).

Tighten the screws (3) to the torque of 43 Nm ± 10% (Sect. 3 - 3, Frame torque settings).

To place the stand switch wiring refer to the table (Sect. 6 - 1, Routing of wiring on frame).

Remove the springs (13) and (14). Unscrew the screws (10) and remove the central stand (11) from the bike.

Place the central stand (11), start the screws (10) and tighten them to a torque of 18 Nm ± 10% (Sect. 3 - 3, Frame torque set­tings).

If removed, apply recommended threadlocker on pin (15) and tighten it to a torque of 10 Nm ± 10% (Sect. 3 - 3, Frame torque settings).